EBS 6900 - Compliance with Standards

The BOLTMARK
®
II‑series PrinTers
Basic OPeraTing insTrucTiOns
62018/02/27#2.0EN
• compliance With standaRds
The manufacturer declares with its full responsibility that when installed and operated in
compliance with the manufacturer’s instrucons, the BOLTMARK
®
II-series printers together
with their manufacturer-supplied accessories meet the essenal requirements and other
relevant provisions of the following European Union Direcves:
• 1999/5/EC,
• 2011/65/UE
and meet the following harmonized standards:
Standard RED Direcve reference
• EN 60950‑1:2006 + A11:2009 + A1:2010
+ A12:2011 + A2:2013,
• EN 50364:2010,
The user and other persons’ health and safety
requirements - with reference to Art. 3,
par. 1 a)
• ETSI EN 301 489‑1 V1.9.2,
• ETSI EN 301 489‑3 V1.6.1,
• EN 61000‑6‑4:2007 + A1:2011,
• EN 61000‑6‑2:2005 + AC:2005,
The protecon requirements with respect to
electromagnec compability - with refer-
ence to Art. 3, par. 1 b)
• ETSI EN 300 330‑1 V1.8.1,
• ETSI EN 300 330‑2 V1.6.1.
Eecve use of the spectrum allocated to
radio communicaon - with reference to
Art. 3, par. 2
Therefore the BOLTMARK
®
II-series printers bear the mark:
* - the number of the noed
body involved in the conformity
assessment procedure.
1471*
The full EC Declaraon of Conformity is available at a client’s request from authorized
distributors.
The BOLTMARK
®
II-series printers are class A equipment as dened by
EN 55022:2010 + AC:2011 (industrial environment). In a domesc environment they may cause
radio interference in which case the user may be required to take adequate counter measures.
comPliance with StandardS