LX2NB Manual v.1.9 Page 16 / 60
tones generated with communicator are treated as data. After transmitting
adequate number of DTMF signs (16 for ContactID) transmitter generates Kissoff
signal. Collection of data from control panel finishes at hanging up a phone of a
control panel by phone communicator module. After that transmitter comes back to
standard operation and awaits for dialling of new number.
If telephone number dialled with communicator is other than number GPRS
module answers, no operation follows and it waits until communicator hangs up a
phone and picks it up again ā since picking up a telephone number dialled with a
communicator module is being checked.
All programmable parameters are saved in memory and in case of voltage
drop that are not lost. Supply of power starts the transmitter with saved settings.
To Next Page
Loading...
