EBS LX2NB - Page 56

LX2NB Manual v.1.9 Page 56 / 60
SERVER=server
Server address; it can be in form of IP or domain
name address.
PORT=port
Server port number.
DNS1=dns1
Specifies primary DNS server address (only needed
when domain name address is used as SERVER
address)
DNS2=dns2
Specifies secondary DNS server address (only needed
when domain name address is used as SERVER
address)
SMS=phone_number
Server phone number. When there is GPRS failure,
SMS with events will be sent to this number.
SMSPERIOD=time
Defines in minutes time between SMS test messages
sending to the server.
OLD
Switch device operating in encoded protocol mode
(LX) into operation in PX emulation mode.
RLIMIT
Removes automatic temporary locks on all inputs
RLIMIT=inputs_mask
Removes selected automatic temporary locks.
Parameter is decimal number made from 9-bit word:
A2, A1, where A2 means INPUT 1, A3 INPUT 2, A4
INPUT 3, A5 INPUT 4.
EXAMPLE:
RLIMIT=6 removes locks on inputs: IN1, IN2
RLIMIT=2 remove lock on input IN1
FLUSH=x
Flushes events buffer, where x is:
 2 – system events history
Note: DESC, CMD, GETSTATUS, GETPARAM, GETCFG commands require separate
SMS, so one command with only one SMS.
Samples of commands and device reaction:
Parameters setting:
1111█APN= general.t-mobile.uk█SERVER=89.112.43.78█PORT=6670█
SMS=500445566█SMSPERIOD=25
Parameters verification:
Inquiry: 1111█GETCFG
Answer: 89.112.43.78:6670,general.t-mobile.uk██,
Inquiry: 1111█GETPARAM=SMS
Answer:: 500445566