TRACKSTAR
EXTREME COMPETITION CONTROLS INC. - ECCI
TRACKSTAR 6000 Series - USB HD Ultra - OWNERS MANUAL
(Edition 5.0 - February 2008)
INDEX
1.0 WHEEL UNIT SETUP AND ADJUSTMENT
2.0 PEDAL UNIT ASSEMBLY AND ADJUSTMENT
4.0 CONNECTING TO YOUR COMPUTER
5.0 ACCESSORY EXPANSION PORT
6.0 POT REPLACEMENT AND POT SETUP
3.0 STEERING RESISTANCE TUNING
3.1
3.3 Steering lock adjustment
3.5 Steering centering pressure at neutral
MONOPOINT IIMONOPOINT II
system
3.4 Steering spring resistance adjustment
3.7 Shift paddle adjustment
4.1 USB HD Ultra equipped wheel & pedal system
4.2 Stand-alone USB HD Ultra pedal unit (no wheel)
3.2 Tuning suggestions
4.3 Calibration - Separated axis mode
4.4 Calibration - Alternate linked axis mode
4.5 Calibration - stand-alone pedal unit (no wheel)
4.6 Properly calibrating the PMB-II brake pedal
7.0 SERVICE AND TECHNICAL SUPPORT
The
3.6 FLDS - fluid damped steering
1.1
1.3 Steering wheel assembly
1.2 Wheel mounting bracket
Unpacking the wheel unit
1.5 Cockpit mounting
1.4 Wheel angle adjustment
2.1
2.3 PMB brake pedal pressure adjustment
2.2 Basic pedal pressure adjustment
Assembly sequence
2.4 Adjusting pedal unit geometry
6.1 Pot replacement procedures
6.2 Checking pots
6.3 Caring for your ECCI system
The contents of this manual, including all descriptions, procedures, and graphics are the exclusive intellectual property
of Extreme Competition Controls Inc and may not be copied or distributed without the written permission of ECCI.
C
2.5 Stabilizing the pedal unit
To Next Page
Loading...