back to the pots, your pedal unit is the same as that provided with a complete system.
Upgrading to a full system will require relocating the logic board to the wheel unit. Instructions
for this will be provided with the upgrade. (Next go to section 4.5)
4.3 CALIBRATION - SEPARATED AXIS MODE (DEFAULT SETTING)
1 Close all other programs first. Then click the Start button. Go to Control Panel and select
Game Controllers from the menu.
2 The Game Controllers dialog box should appear. Windows should automatically
recognize that the ECCI HI-DEF USB controller is connected. If this does not appear
check your connections, and if still no control shows up, reboot and start again.
3 Highlight the controller, and then click on the Properties button. Select the Settings tab
and click on Calibrate. You must follow the prompts carefully to calibrate your system.
Leave the controls untouched to set center point then click a button on the wheel.
4 A square joystick calibration box will appear. It will prompt you to move the controller to
the limits of travel. The steering wheel will be recognized here as the X-axis, moving the
crosshair horizontally in the box. The Y-axis will not be active. After moving the wheel left
and right, release it to center and press a button to move on.
5 Next you will be prompted to verify the center point once again Make sure the wheel is
centered then press a button.
6 A horizontal box with a blue calibration bar will appear. This box will calibrate the gas
pedal. Move the pedal down all the way, release it, repeat several times and press a
button. If the bar does not move fully to the ends of the box, ignore it. This is normal at
this stage of calibration.
7 Another horizontal box will appear. This will recognize the clutch pedal. Move the pedal
down all the way, release it, repeat several times and press a button. If you do not have
a clutch, simply press a button to bypass this step.
8 A third horizontal box will appear. This will calibrate the brake pedal. Move the pedal
down all the way, release it, repeat several times then press a button. If you have a
PMB-equipped unit and wish to reduce the amount of brake pedal pressure to reach
maximum braking, you can ‘short calibrate’ the brake pedal. Press down only as hard as
you wish for maximum braking, release and press a button.
9 After finishing select Test. Carefully observe the movement of your controls in the square
box and the vertical slider bars. Make sure that the wheel and each pedal are recognized
and operating smoothly to their limits of travel. If not, recalibrate. Ignore the inactive slider
bar if you do not have a clutch installed. You are now finished. Click OK to accept
calibration.
4.4 CALIBRATION - ALTERNATE LINKED AXIS MODE
The unit will automatically start up in Separated axis mode which allows independent and
simultaneous operation of pedals. Separated mode is preferable for most sophisticated racing
simulations. However, some gaming titles fail to support separated pedal mode. In this case
you must use linked axis mode.
To Next Page
Loading...