34
TV Guide
Customizing Receiver
2. Using your DTVPal DVR remote
control, press MENU, select
Setup,
then System Setup, then TV
Guide
& Guide +.
Connecting the G-LINK Cable
1. Connect the G-LINK cable to the G-LINK jack on the back of your TV
Guide-enabled TV, DVR recorder, or VCR.
2. Place the G-LINK wand
approximately one inch
in front of the remote
control sensor on your
DTVPal DVR. Use tape
to secure the G-LINK
wand to the DTVPal
DVR front panel.
Note: The remote control
sensor is located in the
middle of the front panel
of your DTVPal DVR.
G-LINK Wand(s)
Connect plug to Guide-
enabled product
G-LINK Wand
G-LINK Wand
IR Sensor
1 Inch
To Next Page
Loading...
