EasyManua.ls Logo

Eclipse EA500 - Page 190

Eclipse EA500
304 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
A PASS message should be displayed.
NOTE: If POWER/FREQ test fails, after pressing RUN TEST, adjust antenna until
PASS message appears. Stop adjusting antenna as soon as PASS message
appears and press STOP TEST button. This test performs a live update of
the dBm values needed to achieve a PASS message for test.
(10) On left PFD, scroll to XPDR using lower softkey.
(11)
Press MODE softkey to change the mode to ALT.
(12) CODE status box on the left PFD and right PFD show 1200.
(13) Press RUN TEST button on Transponder Test Set, IFR6000.
Transponder Test Set, IFR6000 indicates:
A Code = 1200
C Alt = Reading within +/- 100 ft. of the Left PFD altitude reading
(14) On Transponder Test Set, IFR6000, press XPDR button one time. Check that the
following is displayed:
XPDR – ALT ENCODER
(15) On Transponder Test Set, IFR6000, press Source Select button. Check that the
following is displayed:
SOURCE: XPDR
(16) On Transponder Test Set, IFR6000, select RUN TEST.
NOTE: Wait approximately 30 Seconds between cockpit IDENT tests.
(17) Press IDNT key on the Pilot’s keyboard.
IDENT is displayed on Transponder Test Set, IFR6000.
NOTE: IDENT disappears from the IFR test set in approximately 20 seconds.
(18) Press IDNT key on the Copilot’s keyboard (If Installed).
IDENT is displayed on Transponder Test Set, IFR6000.
NOTE: IDENT disappears from the IFR test set in approximately 20 seconds.
(19) Press IDNT button on the Pilot’s Stick Grip.
IDENT is displayed on Transponder Test Set, IFR6000.
NOTE: IDENT disappears from the IFR test set in approximately 20 seconds.
(20) Press IDENT button on the Copilot’s Stick Grip.
IDENT is displayed on Transponder Test Set, IFR6000.
NOTE: IDENT disappears from the IFR test set in approximately 20 seconds.
(21) Press STOP TEST button on Transponder Test Set, IFR6000.
D.
Transponder-2 MODE A,C,S Test using Transponder Test Set, IFR6000
(1) Realign the Transponder Test Set, IFR6000 flat plane antenna to point at the aircraft
Transponder 2 Antenna located in the Center Belly.
EA500 Aircraft Maintenance Manual — 06-117751
Temporary Revision No. 34-21
EFFECTIVITY: 0001-0104, 0113-0115, 0120, 0123-0124
PRE SB 500-99-002 AND SB 500-99-005
34-50-20
CONFIG A
Page 512
Sep 30/20
© 2020 Eclipse Aerospace, Inc.

Table of Contents

Related product manuals