(b) The “ICAO 24-BIT (OCT)” number matches the “AA” ICAO 24-bit code displayed
on the IFR 6000 (above).
NOTE: If the aircraft’s registration number and/or ICAO 24-bit (octal) number are
not present on the MFD’s SETTINGS page, the Aircraft Configuration
File must be updated, refer to AMM-31-40-00-051-801 – Aircraft
Computer Systems - Maintenance Practices. Steps (10) through this step
must then be repeated.
(13) On the MFD, scroll to the SETUP tab, press the SENSOR Soft Key. Set the ADC
PFD source selection from AUTO to ADC 2.
(14)
On the IFR 6000, press the XPDR button once. Once XPDR - ALT ENCODER is
displayed, press the SOURCE SELECT Soft Key until SOURCE - XPDR is displayed.
Press the RUN TEST Soft Key.
(15) Make sure that the altitude reported on IFR 6000 matches L PFD altitude indication
+/- 100 ft.
(16) On the MFD, set the ADC source back to AUTO.
(17) Set the WOW Box Switches to W-on-W (on-ground).
(18) Set XPDR 1 to STANDBY MODE.
EA500 Aircraft Maintenance Manual — 06-117751
Temporary Revision No. 34-21
EFFECTIVITY: NOTED
34-50-20
CONFIG C
Page 522
Sep 30/20
© 2020 Eclipse Aerospace, Inc.
To Next Page
Loading...
