Eclipse EA500 - Page 76

6. Job Close-Up
SUBTASK AMM-34-40-50-071-A-921-002
A.
If no other work is to be performed, turn off the aircraft power by setting the SYS BATT
and START BATT Switches to the OFF (down) position and BUS TIE to OPEN (down)
position.
B. If no other requirements for External Power, disconnect External Battery Pack from the
aircraft EXTERNAL POWER RECEPTICLE.
C. Install (if removed) 331 DT - Upper Overfin Fairing. Refer to AMM-06-50-00-051-801 –
Aircraft Access Panels for location and installation instructions.
D. Install (if removed) 311 AL - Maintenance Bay Panel. Refer to AMM-06-50-00-051-801 –
Aircraft Access Panels for location and installation instructions.
E. Remove all tools, equipment and unwanted material from work area.
F. If all other maintenance is complete, return aircraft to service. Refer to
AMM-20-00-02-051-801 – Return To Service (After Maintenance).
EA500 Aircraft Maintenance Manual — 06-117751
Temporary Revision No. 34-21
EFFECTIVITY: 0001 - 0008, 0010 - 0050, 0052, 0054 -
0267 PRE SB 500-31-024
34-40-50
CONFIG A
Page 514
Sep 30/20
© 2020 Eclipse Aerospace, Inc.