Page 22
ecom-B
At the end of the measurement routine
(curser <down>) it is checked whether a
gas leakage at the unit could be deter-
mined. Confirmation could be done by us-
ing the key <Enter> (yes / no).
The printout (IR printer required) of all re-
sults of the measurement routine could be
done by pressing <Print>.
6.2.2. Oil fan burner
Using Heating oil (B) as fuel type the rou-
tine starts by determining the oil flow and
the thermal capacity brought to the boiler.
Open the menu <Oil pressure> by press-
ing <Enter>. Enter the measured oil pres-
sure as follows:
1. Use the keys <store> (left) and <Print>
(right) to come to the positions which
should be changed (corresponding field is
flashing).
2. Set the number by using the curser
keys.
After setting and pressing <Enter> the sub-
menu nozzle size will be opened. Enter the
used nozzle size like described above.
After setting and pressing <Enter> the
result of the calculation will be displayed.
The calculation can be repeated if needed.
For calculation following heating values are
taken:
Heating oil (B) = 11,86 kWh/kg
Burn. w. blower
To Next Page
Loading...
