EDAN elite V5 - External Device Displaying and Settings on Monitor; NMT Displaying and Settings; V;A (Ventilator and Anesthetic Device) Displaying and Settings

Patient Monitor User Manual V-Link Module
- 188 -
21.6 External Device Displaying and Settings on Monitor
Illustrations in this manual serve as examples only. The content displayed on your monitor
depends on the way it has been tailored for your hospital.
NOTE:
The patient information for Ventilator or Anesthetic device is from external device. If the
patient information on external device is inconsistent with that on the monitor, there will
be a prompt Inconsistent patient type (XX) on the monitor. XX represents one of the
external devices, Ventilator or Anesthetic device.
21.6.1 NMT Displaying and Settings
NMT provides 5 stimulation methods: SS, TOF, PTC, DBS and TET.
Stimulation method Parameter
SS Tw
Temp
TOF TOFrat
TOFcnt
Temp
PTC PTCcnt
PreTw
Temp
DBS Temp
TET Temp
Selecting User Maintain > Color Setup can change color of parameter and waveforms.
Parameter Stimulation Method Measurement mode
Measurement value Measurement bar
NMT Displaying Interface
21.6.2 V/A (Ventilator and Anesthetic Device) Displaying and Settings
User can press the Anes/Vent shortcut key on the screen directly or select Anes/Vent in Display
Setup > View Selection menu to open the Anes/Vent window. Selecting other options in View
Selection can exit this window. Depending on the device connected, the Anes/Vent window
varies. When the device is connected successfully, the currently-used source device name is
shown in the Anes/Vent window title.