EDAN elite V5 - Chapter 22 Lidco Module; Overview; Lidco Displaying and Settings; Alarms from Lidco Module

Patient Monitor User Manual LiDCO Module
- 192 -
Chapter 22 LiDCO Module*
*Not available in USA.
22.1 Overview
The supported external devices LiDCOplus or LiDCOrapid can be used for hemodynamic
monitoring.
22.2 LiDCO Displaying and Settings
LiDCO provides the parameters, including CO, CI, SV, SI, SVR, SVRI, DO
2
, DO
2
I, SaO
2
, CVP,
HR, MAP, DIA, SYS, SVV, PPV, SPV and HRV.
Parameter name
Unit Value
Parameter name
Unit Value
Parameter name
Unit Value
Parameter name
Unit Value
Parameter name
Unit Value
Parameter name
Unit Value
Parameter name
Unit Value
Parameter name
Unit Value
LiDCO Displaying Interface
Selecting
User Maintain > Color Setup can make color changes on parameter and waveforms.
Click on the LiDCO displaying area, open the setup menu, user can view the
Mode (Beat),
Patient Info and Auxiliary Info (such as CF, HB, BSA, CVP, SaO
2
, etc.).
NOTE:
The interval mode of LiDCO device is not supported on the monitor.
•
Select the parameters to be displayed.
• Select Default to restore factory default for all this menu setup of this module.
22.3 Alarms from LiDCO Module
For LiDCO module: the monitor won’t give out any indications and parameter alarm off symbol
will be displayed.
NOTE:
1 The patient information for LiDCO module is from external device. If the patient
information on external device is inconsistent with that on the monitor, there will be a
prompt Inconsistent patient type (LiDCO) on the monitor.
2 For LiDCO module, if technical alarm “XX Comm Fail” is reset, the alarm (including
visual and audio alarm indications) will be cleared.