SE-2003&SE-2012 Holter System Recorder User Manual
- 32 -
5.3 Recording Status
The SE-2003/SE-2012 will shift from recording process to information display mode to display
current date, time, recording time, patient information and recording parameters. Only one second
is needed to shift to real-time waveform display mode by pressing left-up key and confirmation
key together.
5.3.1 Information Display
Current date, time, recording time, patient information and recording parameters are displayed in
a top-down order.
If recording time is not 24 hours, reverse signal of 2, 3, 4, 0 (continuous recording) will show up;
If recording channel of SE-2003 is set to 3, reverse signal of 3 will show up;
If recording channel of 3-channel recording is set to 2 or 1, reverse number of 2 or 1 will show
up;
If electrodes fall during recording process, reverse signal of the name of fallen electrode will
show up;
Indications of ERA, WAIT and REC reflect working status. Reverse signal of END will show
up at the end of recording.
Meanings of various states will be specified in other sections.
The recorder will erase the existing data first and wait for two minutes to stabilize the circuit and
ECG electrodes.
NOTE: Erasing time varies with SD card models and working time. SD card needs to be
changed in case erasing time is over 2 minutes.
Date
Time passed
Pacing record
Patient
information
End of record
3 days
Electrodes fall
Remind
Patient event
To Next Page
Loading...
