EDAN SE-2003 - Cleaning and Maintenance Procedures; Cleaning the Patient Cable; Routine Visual Inspection

SE-2003&SE-2012 Holter System Recorder User Manual
- 36 -
6 Cleaning, Care and Maintenance
CAUTION
1. Remove the battery and the patient cable from the recorder before cleaning.
2. Prevent any liquid from seeping into the recorder; otherwise the safety and the
performance of the recorder can not be guaranteed.
6.1 Cleaning the Patient Cable
CAUTION
Any remainder of detergent should be removed from the patient cable after cleaning.
To clean the patient cable:
1. Dampen a soft cloth with one of the disinfectants or cleaning agents listed below.
2. Wring excess moisture from the cloth before cleaning.
Recommended Cleaning Solutions
♦ Mild soap and water
♦ 75% alcohol
6.2 Care and Maintenance
6.2.1 Visual Inspection
Perform a visual inspection of all equipment and peripheral devices daily. If you notice any items
that need repair, contact a qualified service engineer to make the repairs.
♦ Check the case and display screen for cracks or other damage.
♦ Regularly inspect all plugs, cords, cables, and connectors for fraying or other damage.
♦ Verify that all cords and connectors are securely seated.
♦ Inspect keys and controls for proper operation.