37
EAS Power Switch
The EAS Power Switch allows you to control your favorite aftermarket
accessories such as lights, air compressors, etc. directly through the CTS3
Upon starting the CTS3 for the rst time with the EAS device installed, you may
go straight to changing Switch settings, or you may opt to go to the home menu
and navigate to the EAS Settings Menu at any time after to change the Switch
Names and Descriptions.
When an EAS Power Switch is connected to a CTS3, a new switch page is
automatically added to the Gauged
mode. It is added in the very rst slot,
to the far left of the gauge pages.
The switch page will be automatically
populated with connected switches
(up to 4). You also have the option of
placing a switch on any digital gauge.
Switch Operation:
• A single tap on a switch, or digital gauge holding a switch, will change the state of
the switch.
• A long press and hold on a switch, or digital gauge holding a switch, will enter the
Switch Customization Menu.
Switch Customization Menu:
Users can change the switch look, and LED color through this menu.
Gauges Mode Operation with EAS Power Switch connected:
• If an EAS Switch module is present, the sleep timer is extended to 30 seconds. The
30 second timer is also used if a device is woken up by a tap (warm boot).
• If a switch is toggled to the ON position, the sleep timer is suspended until the switch
is toggled to the OFF position. Once the switch is toggled OFF, the sleep timer will
begin counting down.
EAS Device Instructions Cont’d
To Next Page
Loading...
General