18
Power Cord Removal and Replacement Instructions
The air breaker functions to supply water for wash and rinse while preventing siphoning or back-flow of
wash water into the water supply. It also functions to supply air venting to aid in dish drying.
Tools and Parts Needed:
- Phillips Screwdriver - Flat Tip Screwdriver - Needle nose pliers
Step 1: Remove Base Tray Cover
Refer to instructions to remove panel found in the “Drain Pump Removal and Replacement”
section of this document
Step 2: Locate the Connector Bracket
Step 3:Remove Crimp Connectors and Disconnect Power Cord Wiring
Remove three (3) Crimp Connectors that are seated into the Connector Bracket.
o
Turn the pump clockwise until the locking latch clicks and the pump is locked in place.
To Next Page
Loading...
