50
Door Switch Removal and Replacement Instructions
The door switch signals to the circuit board that the door is closed properly and the unit can begin a cycle.
A failing switch may lead to an error code, failure to turn on, or it may even allow the unit to run without
the door closed properly.
Tools Needed:
- Phillips Screwdriver - Flat Tip Screwdriver - Needle nose pliers
Step 1: Remove the Outer Shell
Remove the eight (8) screws as indicated in the below image. Set screws aside
Lift up on the outer shell and unlatch from the front of the unit. Set outer shell aside
To Next Page
Loading...
