35
Heating Element Removal and Replacement
The heating element heats water as needed during wash and rinse cycle.
Tools Needed:
- Phillips Screwdriver - Flat Tip Screwdriver - Needle nose pliers
- 8mm socket wrench
Step 1: Remove Base Tray Cover
Refer to instructions to remove panel found in the “Drain Pump Removal and Replacement”
section of this document
Step 2: Remove the wash pump assembly
Unhook the rubber mounting straps for the motor assembly where indicated in the below images.
Use a flathead screwdriver to slide the rubber hold-downs up and over the plastic latch assembly.
NOTE: Be careful not to tear the rubber
To Next Page
Loading...
