26
Check Valve Removal and Replacement
The check valve is a one way valve that prevents wastewater in the drain system from flowing back into
the pump.
Tools and Parts Needed:
- Phillips Screwdriver - Flat Tip Screwdriver
- Needle nose pliers - Gear drive hose clamp (1)
Step 1: Remove Base Tray Cover
Refer to instructions to remove panel found in the “Drain Pump Removal and Replacement”
section of this document.
Step 2: Remove the hose clamp on the drain pump
Use a flat tip screwdriver to pry the clips securing the ends of the crimp clamp together.
Remove clamp and discard. The original crimp clamps are not reusable. Gear drive hose clamps (not
supplied) are required to complete the repair.
To Next Page
Loading...
