EdgeStar DWP62BL - Float Assembly, Float Micro Switch and Float Removal and Replacement Instructions

33
Float Assembly, Float Micro Switch and Float Removal and
Replacement Instructions
Tools Needed:
- Phillips Screwdriver - Flat Tip Screwdriver - Needle nose pliers
Step 1: Remove Base Tray Cover
 Refer to instructions to remove panel found in the “Drain Pump Removal and Replacement”
section of this document
Step 2: Remove the float assembly cover
 Pinch the two cylindrical latches and slide the cover up over the clips exposing the Styrofoam
float
Step 3: Remove and replace the micro switch
 Using needle nose pliers and push against the two grey latches to release the micro switch
 Slide the new micro switch into the latches in the same orientation
NOTE: If replacing the Styrofoam float itself, simply lift the float over the cylindrical latches and slide the
new float into place