44
Step 3: Remove the Soap Dispenser
NOTE: This is a good time to take some pictures of the electrical connectors so you may refer back to
them during reassembly
Use needle nose pliers or a flat tip screwdriver to remove the electrical connectors from the soap
dispenser
NOTE: One of the locking electrical connectors may not be accessible with the dispenser installed. You
may have to remove the brackets and push the dispenser partially through the inner door to get access to
the backside of the connector.
Remove the 6 screws holding the two brackets that attach the soap dispenser to the door
NOTE: The lower screws also attach a bracket that attaches to the bottom of the soap dispenser
To Next Page
Loading...
