A small amount of water (in sump area) is normal
This is necessary to keep the pump primed
and is drained automatically at the beginning
of each cycle
Clean or Replace the Check valve
Clean for debris in Air Breaker
Spotting or filming on
glasses
Detergent allowed to stand too long in the
dispenser or excessive amounts of detergent are
being used
Instruct the customer on proper use of
dishwasher detergent Refer to the owner’s
manual
Improper loading of dishes, pots, pans, and
nesting of silverware
Debris in bottom of tub sump area
Pump parts were not properly installed
Inspect the pump and correct and installation
errors
Clean the filter assembly
Dishware blocking the spray arm
Adjust dishes and rotate spray arm before
wash
Improper loading of dishes, pots, pans, and
nesting of silverware
Refer to the owner’s manual
Replace the soap dispenser
Check spray arm for proper rotation and
cleanliness
See “Too little water fill” symptom
Improper loading of dishes, pots, pans, and
nesting of silverware
Instruct the customer on proper loading of the
dishwasher Refer to the owner’s manual
Improper program / cycle selection
Replace the soap dispenser
Water leaks from
dishwasher
Replace air breaker or PCB assembly
Soap suds leak from dishwasher
Refer to use and care manual
Tighten or replace hose clamps
Drain pump assembly not seated properly with
sump
Remount the drain pump assembly
To Next Page
Loading...
