12
2. Press and hold the WPS button on your wireless router/access point for
the correct length of time to activate its WPS.
Please check the instructions for your wireless router/access point
to confirm how long you need to hold down its WPS button to
activate WPS for 2.4GHz or 5GHz. Some brands of router/access
point may not support WPS for 5GHz – in this case, please refer to
II-1. iQ Setup instead.
3. Within two minutes, press and hold the WPS button on the CV-7438nDM
for 2 seconds to activate the WPS function. The LED should flash (white) to
indicate that WPS is in progress.
4. The devices will establish a connection. When a connection is successful,
the bridge’s LED will display on (white). If a connection is not successful,
the LED will flash (red) – in this case please return to II-2. WPS Setup Step
1.
To Next Page
Loading...
Need help?
General
