V-5-2 Advanced
The “Advanced” page allows you to upgrade the network camera’s firmware,
backup or restore the network camera’s settings, and reset or restart the
network camera. Please check the Edimax website for the latest firmware for
your network camera.
Do not switch off or disconnect the device during a firmware
upgrade, as this could damage the device.
Click “Browse” to locate the firmware file on your computer.
Click to upgrade the firmware to your selected file.
Click “Apply” to save the current settings on your computer as
config.bin file.
Click “Browse” to find a previously saved config.bin file and
then click “Upload” to replace your current settings.
Click “Restart Network Camera” to restart the network camera.
Please wait a couple of minutes for network camera to boot up
after a restart. Restarting will not affect the camera’s current
configuration.
Select “Keep Network Settings” or “Default Settings” and then
To Next Page
Loading...
