ES-12B 5 Terminal Single Phase Residential Electricity
Meter - Installation and Commissioning Guide
Copyright © 2020 EDMI Europe Ltd. All rights reserved
Version / Status: 1.0
Public
The meter received a bad
message from the
Communications Hub (e.g.
message with bad data, an out
of sequence number, or a
message with a bad format) and
has terminated the key
establishment.
If a flying lead has been used
there may be something
blocking the signal or a high
level of electromagnetic noise
may be causing issues.
Attempt to join the HAN again –
if the error persists please
contact your support centre
The meter or Communications
Hub does not currently have the
internal resources necessary to
perform key establishment and
has terminated the exchange.
Attempt to join the HAN again –
if the error persists please
contact your support centre
The device does not support the
specified key establishment
suite in the partner’s Initiate Key
Establishment message.
Attempt to join the HAN again –
if the error persists please
contact your support centre
If ‘Comis Waiting’ is persistent,
the Meter is not receiving any
GBCS commands from the
Communications Hub. This
could either mean issues with
the WAN or the Hub itself.
Please refer to the
Communications Hub
installation manual and/or
associated user guide from your
Comms hub manufacturer.
10.4 The ESME does not default to the “Join HOLD OK” screen upon power up
After power has been applied to the ES-12B, the LCD display screen on the meter should
display “Join HOLD OK”.
If the installed ES-12B meter does not default to the “Join HOLD OK” screen upon power up of the
meter, please follow the steps stated below:
1. From Import screen, press ‘OK’ on the meter.
2. Scroll to ‘Info’, press ‘OK’
3. Scroll to ‘Join’ press ‘OK’
The engineer is now at the correct screen to select “Join HOLD OK”.
To Next Page
Loading...
