Edwards E2M30

Figure 8 Motor voltage selecon: single-phase motors, 110/200-240 V 50 Hz and
115-120/200-240 V 60 Hz
BA
CS/1118/A
1
3
4
5
7
8
6
2
A. Top view of motor B. Internal view of top of motor
C. On/O switch
A. Top view of motor B. Internal view of top of motor
C. On/O switch
1. Terminal box cover 2. Electrical inlet socket
3. On/O switch 4. Posion 'I' (on)
5. Posion 'O' (o) 6. Voltage selector switch
7. Posion 'II' (high voltage seng
200‑240 V)
8. Posion 'I' (low voltage seng
110‑120 V)
1. Terminal box cover 2. Electrical inlet socket
3. On/O switch 4. Posion 'I' (on)
5. Posion 'O' (o) 6. Voltage selector switch
7. Posion 'II' (high voltage seng
200‑240 V)
8. Posion 'I' (low voltage seng
110‑120 V)
4.7 Electrical installaon: three-phase motors
4.7.1 Connect the electrical supply to the motor
WARNING:
Ensure that the electrical installaon of your pump‑motor conforms with your local
and naonal safety requirements. It must be connected to a suitably fused and
protected electrical supply and a suitable earth point.
CAUTION:
If your pump‑motor can be used with more than one voltage range, you must ensure
that the motor is congured for your electrical supply voltage. If you do not, you may
damage the motor.
Note:
The pump will restart automacally when the electrical supply is restored aer an
interrupon. If you do not want the pump to restart automacally, use electrical control
equipment which must be reset manually.
Page 24
A37310880_V - Installaon