A344-02-880 Issue J
Page 18 © Edwards Limited 2007. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
3.8.2 Connect to ISO40 fittings
From the fitting pack, use the two ISO40 Co-seal halves, ISO40/NW40 seal, bolts and washers. Connect to your ISO40
fittings as shown in Figure 7.
3.8.3 Connect to NW40 fittings
From the fitting pack, use the NW40 Co-seal half, ISO40/NW40 seal, the 'C clamp and the bolts and washers. Connect
to your NW40 fittings as shown in Figure 8.
Figure 7 - Connect inlet to ISO40 fittings
Figure 8 - Connect inlet to NW40 inlet fittings
To Next Page
Loading...
