A705-61-880 Issue M
Page 18 © Edwards Limited 2012. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
3.8 Fit a mechanical booster pump (optional)
If you want to use a mechanical booster pump with the GV pump, fit it now. Details of the connection kits available
from Edwards are given in Section 7.4. Refer to the installation procedures in the instruction manual supplied with
the connection kit.
Figure 4 - Connect to the thermal snap-switches
1. Bolts (4 off)
2. Cover
3. Thermal snap-switch box
4. Four-core cable
5. Cable-gland
6. Warning wires
7. Spade terminals
8. Warning thermal snap-switch
9. Shut-down thermal snap-switch
10.Spade terminals
11.Shut-down wires
To Next Page
Loading...
