Edwards iXL120N

© Edwards Limited 2010. All rights reserved. Page 3
Edwards and the Edwards logo are trademarks of Edwards Limited.
Introduction
A541-11-880 Issue A
1.3 The iXL120 system
The iXL120 is a compact dry pump system that can be mounted on tool or remotely. The pumping system can be
controlled from the front control panel, a PDT accessory or by the tool via a MicroTIM.
Figure 2 - The controls/connectors
1. Nitrogen purge connection (if fitted)
2. Cooling water supply connection
3. Transit/lifting/seismic bracket (if fitted, 2 off)
4. Cooling water return connection
5. Exhaust outlet connection
6. Mains power connection
7. Protective Earth (ground) stud M5
8. Electrical connector locking mechanism
9. Accessory interface
10. System control/PDT connection
11. Ethernet installed LED
12. Ethernet connection
13. Ethernet active LED
14. Indicator LED - Tool in control
15. Emergency stop (EMS) connection
16. Tool interface connection (if fitted)
17. Pump inlet
17a. Pump inlet (NW50 connection)
17b. Pump inlet (ISO63 connection)