© Edwards Limited 2010. All rights reserved. Page 43
Edwards and the Edwards logo are trademarks of Edwards Limited.
Appendix A1
A541-11-880 Issue A
A1.1.4 Menus
There are three menu buttons Normal, Status and Setup described below.
NR in the data part of a parameter indicates No Reading.
NP in the data part of a parameter indicates a parameter that is Not Present.
A1.1.4.1 Normal menu
This menu is displayed when the PDT is first plugged into the pump, or accessed by pressing Normal button. Up to 4
parameters displayed, scroll by pressing up/down keys.
By default the 4 parameters displayed in the Normal menu are as shown above, these may be changed using Edit
Display attributes menu in SETUP.
A1.1.4.2 Status menu
Press the Status button to enter. Scroll by pressing up/down keys. Press CANCEL to exit back to Normal menu.
If a device is not fitted the associated parameters will not be displayed. Parameters displayed:
Table A3 - Normal menu
Description Typical Display
Serial Number S/N 1234567
Control Holder NONE IN CONTROL
Dry Pump current DP CURRENT 4.0 A
Dry Pump speed DP SPEED 150 Hz
Table A4 - Status menu
Description Typical display
Serial Number S/N 1234567
Control Holder NONE IN CONTROL
Dry Pump current DP CURRENT 4.0 A
Green mode GREEN MODE Off
Dry Pump temperature DP TEMP 100 °C
Dry Pump Power DP POWER 0.52 kW
Dry Pump speed in percent DP SPEED 100%
Dry Pump speed in Hz DP SPEED 150 Hz
Dry Pump inverter temperature DP INV TMP 100 °C
Run Hours RUN HOURS 1000
Number of Pump Starts PUMP STARTS 100
Time to Stop (seconds) TIME TO STOP 900
Active Alarms and Warnings
To Next Page
Loading...
