© Edwards Limited 2010. All rights reserved. Page 21
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
A541-11-880 Issue A
Figure 5 - Connect the electrical supply
3.8.1 Electrical connector locking mechanism
This product is approved permanently connected equipment and must be used as described below.
Figure 6 - Electrical connector locking mechanism
1. 3-Phase mains cable.
2. Cable gland
3. Hood (M25)
4. Gasket
5. Screw Module (female)
6. Housing
7. Screws x 4
1a.Locking mechanism - Locked position
1b.Locking mechanism - Unlocked position
2. Locking screw
3. Lever
To Next Page
Loading...
