EasyManua.ls Logo

Edwards iXL120N

Edwards iXL120N
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
A541-11-880 Issue A
Page 44 © Edwards Limited 2010. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Appendix A1
A1.1.4.3 Setup menu
Press the Setup button to enter. Menu title is shown at the top of the display. Scroll by pressing up/down keys. Press
ENTER to open a sub menu or CANCEL to exit back to Normal menu.
Each sub menu is described below.
A1.1.4.4 Commands menu
Under the Setup menu. Scroll by pressing up/down keys. Press ENTER to open a sub menu or CANCEL to exit back to
the SETUP menu.
Press the up/down keys to select the new settings and press ENTER to accept or CANCEL to exit back to the
COMMANDS menu.
A1.1.4.5 Display Inverter Fault History (inv fault hist) menu
Under the Setup menu. Scroll by pressing up/down keys. Press ENTER to open a sub menu or CANCEL to exit back to
the Setup menu.
Each inverter fault history contains up to 32 entries, each contains one alarm and one warning, where 1 is the most
recent. Scroll by pressing up/down keys. Press CANCEL to exit back to the Inverter Fault History menu.
A1.1.4.6 Software version display menu
Under the Setup menu. Scroll through the software version loaded in the processors by pressing up/down keys. Press
CANCEL to exit back to the SETUP menu.
Table A5 - Setup menu
Description Display
Commands menu
*
*
This option requires a security code to access it.
Command Menu…
Display Inverter Fault History menu Inv Fault Hist…
Software Version Display menu S/W Version…
Display Serial Number Serial Num…
Fit Accessory menu
*
Fit Accessory…
Edit IP configuration menu IP Config…
Edit Display attributes menu Display Attr…
Set Time and Date
Time is set automatically when connected to a Fabworks network.
Set Clock…
Display Pump Type Show Pump type...
Table A6 - Commands menu
Gate Valve (Open/Shut)
*
*
This option requires a security code to access it.
Green mode (On/Off)
The PDT must be in control to perform this function.
Table A7 - Display inverter fault history menu
DP Inv Fault Hist (Dry Pump Inverter Fault History)

Table of Contents

Related product manuals