Edwards iXL120N

© Edwards Limited 2010. All rights reserved. Page 45
Edwards and the Edwards logo are trademarks of Edwards Limited.
Appendix A1
A541-11-880 Issue A
A1.1.4.7 Fit accessory menu
Under the Setup menu. Scroll by pressing up/down keys. Press ENTER to open a sub menu or CANCEL to exit back to
the Setup menu.
For an accessory press the up/down keys to select Fitted or Not Fitted and press ENTER to accept or CANCEL to exit
back to the COMMANDS menu. Gate Valves additionally have an option of Fitted No Feedback for use where there
are no position feedback switches fitted to the gate valve.
A1.1.4.8 IP configuration menu
Under the Setup menu. Scroll by pressing up/down keys. Press ENTER to open a sub menu or CANCEL to exit back to
the Setup menu.
Display only items press CANCEL to exit back to the IP Configuration menu.
Table A8 - Fit accessory menu
Item Description
Gate Valve…
Water Sensor… (Analogue water flow)
Active Gauge…
Exh Gas Temp… (Exhaust Gas Temperature)
Table A9 - IP configuration menu
Item Description
Host_Name… (display only)
DHCP Enable… (Enabled / Disabled)
*
*
Press the up/down keys to select Enabled or Disabled and press ENTER to accept or CANCEL to exit back to
the IP Configuration menu.
IP Address… (xxx.xxx.xxx.xxx)
†
†
For each address setting press the up/down keys to set the digit, press ENTER to accept and move to the
next digit or CANCEL to move back to the previous digit. Pressing ENTER at the end of the line will accept
the new setting and exit back to the Edit IP menu. Pressing CANCEL at the start of the line will cancel and
exit back to the IP Configuration menu.
Address Mask… (xxx.xxx.xxx.xxx)
†
DNS Server… (xxx.xxx.xxx.xxx)
†
Gateway… (xxx.xxx.xxx.xxx)
†
NTP Server… (display only)
SMTP Server… (display only)
MAC Address… (display only)
Domain Name… (display only)