UPS: MKD 700 – 3000 VA RT (XL) Introduction
Due to the possibility of existing energy storage (accumulators) within a UPS,
devices must generally be inspected by EFFEKTA Regeltechnik GmbH or a
qualified service center after transportation damages. In the case of
transportation damages, there is a high risk that the energy storage units and/or
their electrical connections have been affected. As a result, short circuits and/or
the leaking of electrolytes cannot be ruled out. For this reason, the unit must be
isolated until an inspection has been performed.
In addition, the device should not be transported or stored upside-down.
2.6 Positioning
Only operate the UPS in well-ventilated rooms, ensuring the specified ambient
temperature range (according to 13 Technical dat).
The UPS should not be placed in the vicinity of heat sources. In the event of
increased ambient temperature (higher than 25°C), the life span of the battery
will decrease considerably; as a result, the battery’s warranty will be terminated.
Always take the operating conditions into account when positioning the device.
Maintain the minimum distance to adjacent equipment and walls necessary for
ventilation purposes (see 13 Technical dat and 5 Installation and
connection of the UPS ensure that the necessary air circulation is provided.
Never place or operate the device in a moist environment. Liquids must, as a
rule, be kept away from the device.
Due to major temperature differences, condensation or dew effects may occur
after the positioning of the UPS. Therefore, an acclimatization period of at least
two hours must be observed before any further steps are taken. Make sure the
temperature adjustment has been completed and that any surfaces with
condensation inside and outside the device have completely dried.
Never operate the UPS in an explosive and/or unventilated setting.
2.7 Connection
Always use the connection terminals or blocks provided for the purpose of
connecting the UPS.
To Next Page
Loading...
