Printer Setup
Document ID: OMM-00174 Rev. D Pro 30f Operations Guide 38
7. Check the negative pressure to verify that it is
normal. If not, use the PLC GUI (Controls/Ink
window) to set it to the correct values (-3.3 kpa for
CMYK and -3.6kpa for White).
8. Clean the print heads one by one with a lint-free wipe soaked with flush.
See 8.0 Print Head Care.
9. Purge the CMYK ink by pressing the CMYK ink purge button. See Figure
5-10Then repeat for W. Ink drops will be observed on the nozzles of the
print heads.
Figure 5-9 : PLC GUI (Controls/Ink Window)
F Negative Pressure values
F
Figure 5-10 : Ink Purge Panel
GPurges CMYK
HPurges White
G H
To Next Page
Loading...
