WARNING: TO REDUCE THE RISK OF INJURY, READ ALL INSTRUCTIONS!
All work on this product (system design, installation, operation, setting, configuration, and
maintenance) must be carried out by qualified personnel. To reduce the risk of electric shock, do
not perform any servicing other than those specified in the operating instructions unless
qualified to do so.
1. Read all instructions before commencing installation. For electrical work, follow all
local and national wiring standards, regulations, and these installation instructions.
All wiring should be in accordance with the National Electrical Code (NEC),
ANSI/NFPA 70.
2. The battery and system can connect with the utility grid only if the utility provider
permits. Consult with the local AHJ before installing this product for any additional
regulations and requirements for the area.
3. All warning labels and nameplates on this battery should be clearly visible and must
not be removed or covered.
4. The installer should consider the safety of future users when choosing the battery’s
correct position and location as specified in this manual.
5. Please keep children away from touching or misusing the battery and relevant
systems.
The battery is designed to stop charging when reaching the low threshold of 32°F. If charging
current is observed when the internal battery temperature is below 32°F, disconnect battery
immediately and consult manufacturer.
DISCLAIMER
EG4 reserves the right to make changes to the material herein at any time without notice.
Please refer to www.eg4electronics.com
for the most updated version of our manuals/spec sheets.
To Next Page
Loading...
