4. UL 1973 CONDITIONS OF ACCEPTABILITY
The products covered in this Report are incomplete in construction features or limited in performance
capabilities and are intended for use and evaluation in other products.
Consideration should be given to the following when the component is used in or with another product.
1. The battery module SR-48-100-LP4-IN-02 (LifePower4 V2) had been evaluated based upon
manufacturer’s specifications for charging, discharging and temperature limits. They have not
been evaluated in combination with charger(s) or other control systems in the end use
application. Additional evaluations are needed in the end product to determine the compatibility
of assemblies with other systems and to ensure that the assemblies are used within their normal
operating regions.
2. The battery module Model SR-48-100-LP4-IN-02 does not consider environment test included
Salt Fog Test. The acceptance of the battery pack shall be determined in the end use
application if the battery pack was used near marine environment.
3. The battery module SR-48-100-LP4-IN-02 is intended to be used in indoor use only. It does not
have an enclosure with a UV / Water exposure rating for use in outdoor locations, additional
evaluation needed if exposed to sunlight or water in the end use application.
4. The battery module SR-48-100-LP4-IN-02 was dropped from a height of 10cm. If it was installed
and serviced more than 10cm in the end use application, the acceptance shall be determined by
the end use application.
5. The battery module SR-48-100-LP4-IN-02 has not been evaluated for multiple BATTERY
MODULE in parallel or series. Additional evaluation and testing may be needed in the end use
application.
6. The instructions for the proper installation and use including charging and discharging, storage,
recycling and disposal shall be required for the end use application. These instructions shall
include temperature limits, charging and discharging limits as well as instructions regarding the
use of any controls or monitoring systems.
See sections 2 – 5, 10, and 14 for detailed installation instructions to meet these conditions.
To Next Page
Loading...
