EGO Induction Gx - Page 23

product operating instruction
E.G.O. Germany (E.G.O. Elektro-Gerätebau GmbH)
document id.: 90.60160.286-001-04-A / state: 230 - released
designation: Induction Gx
page
23
of
43
10 Positions for assembling the inductors to the mounting plate
4. The cables of inductors must be put down without any push or pull forces towards the inductor
(picture 12) that the inductors can bounce. It must be ensured that the NTCs of the inductors have
always contact to the glass.
It must be ensured that the cables are not push up the inductor or from the side and are not prevent
a free bouncing of inductors (picture 11). Therefore, a laying of the cables under the inductor and
between the micanite discs is not allowed.