300781 • 1/2019 • H.S.
36 of 70
Operating Instruction
High Pressure Cleaner cold water, mobile
Series 3x3
4 Installation
4.6 Device assembly
4.6.1 Device version Standard
General information
The following assembly instruction provides a general example of
assembling the device version Standard.
The assembly procedure for device version KD940-F-Standard (food
appliance with stainless steel components) is the same.
For device assembly proceed as follows:
Installing the handle
○ Insert the handle into the chassis openings provided for this
purpose.
○ Position the two screw holes integrated in the handle to
match the chassis screw inserts.
Fixing the handle
○ Provide the two attachment screws with washers.
○ On each side, guide the attachment screw through the
handle hole into the insert and tighten by hand.
○ Tighten both screws with an open-end wrench 13 mm.
Connecting HP-Hose to pump
○ Connect the HP-Hose to the high pressure outlet of the pump
(high pressure outlet).
To Next Page
Loading...
