Błąd! Użyj karty Narzędzia główne, aby zastosować 标题
1 do tekstu, który ma się tutaj pojawić. Błąd! Użyj karty Narzędzia główne, aby zas
tosować 标题 1 do tekstu, który ma się tutaj pojawić.
Page 20 / 37
Firstly, the handpiece will heat to about
150℃ to melt the residual Gutta-percha.
Secondly, the pushrod pushes forward
until the Gutta-percha is exhausted. the
direction of push rod movement displays
on the screen.
Then, the direction and position of push
rod display on the screen. The push rod
needs returning to original position. This
operation needs about 50 seconds.
Finally, when the push rod is back to
original position, “Please insert GP” will
display on the screen. Press any key to exit
and return to standby interface.
During this state, press can stop and return to standby interface.
After pushing the Gutta-percha bar into
handpiece with medical forceps, screw
down the cartridge.
If there is some Gutta-percha in the
handpiece, it is inconvenient to install the
Gutta-percha bar. Push the residue to the
bottom of cavity with the pin on bending
tool.
To Next Page
Loading...
