Eighteeth Fast-Fill - 8.3 Cleaning, Disinfection and Sterilization

Błąd! Użyj karty Narzędzia główne, aby zastosować 标题
1 do tekstu, który ma się tutaj pojawić. Błąd! Użyj karty Narzędzia główne, aby zas
tosować 标题 1 do tekstu, który ma się tutaj pojawić.
Page 24 / 37
Push the cleaning rod against the bottom
of the silver tube and press it into place.
NOTE
If the installation is not in place, please
contact the supplier to use professional
tools for maintenance.
Push the protective cover into the silver
tube.
8.3 Cleaning, Disinfection and Sterilization
8.3.1 Foreword
The parts for clinical application contamination are the outer surfaces of the cartridge
and bending tool. For hygiene and sanitary safety purpose, the components
(cartridge and bending tool) must be cleaned, disinfected and sterilized before each
usage to prevent any contamination. This concerns the first use as well as the
subsequent uses.
Comply with your national guidelines, standards and requirements for cleaning,
disinfection and sterilization.
8.3.2 General recommendations
⚫ The user is responsible for the sterility of the product for the first cycle and each
further usage as well as for the usage of damaged or dirty instruments, where
applicable after sterility.
⚫ For your own safety, please wear personal protective equipment (gloves, safety
glasses, etc.).
⚫ Use only a disinfecting solution which is approved for its efficacy (VAH/DGHM-
listing, CE marking, and FDA approval) and in accordance with the DFU of the