Błąd! Użyj karty Narzędzia główne, aby zastosować 标题
1 do tekstu, który ma się tutaj pojawić. Błąd! Użyj karty Narzędzia główne, aby zas
tosować 标题 1 do tekstu, który ma się tutaj pojawić.
Page 30 / 37
9.Troubleshooting
When trouble is found, check the following points before contacting your distributor.
If none of these are applicable or the trouble is not remedied even after action has
been taken, the product may have failed. Contact your distributor.
The power is
not turned on.
Press the power switch too
short time.
Long press the power
switch.
The power LED
on charge base
does not light.
Use the original
adapter.
The adapter is not connected.
The plug of the adapter is not
inserted into the outlet.
There is no electricity in the
outlet.
No charge
indicator flash
on handpiece
screen.
Put the handpiece into the
charge base in the wrong
direction.
Charge pin of charge base is
unable to rebound.
Remove debris which
between move part and
base of the charge pin.
Cleaning the surface of
contactors.
The charge base is broken.
Connect adapter to
handpiece directly, and
contact your distributor.
Handpiece
screen does not
appear.
Check if there is a sound
of beep, and contact
your distributor.
Set beep volume to 1, 2
or 3.