35
Chapter 5 Power Saving Functions
5-2. Adjusting the Brightness of Indicator
The brightness of the power indicator (blue) can be adjusted. (Default setting: 4)
Procedure
1. Choose “PowerManager” from the Adjustment menu, and press
.
2. Choose “Indicator” from “PowerManager”, and press
.
3. Select the indicator brightness “Off” or in the range from 1 to 7 with
or as desired.
4. Press
to exit.
5-3. Checking the Power Saving Level
The EcoView menu allows you to check Power Reduction, CO
2
Reduction, and Eco Performance Level. The more
indicators light up representing the Eco Performance Level, the higher the power saving level attained.
Procedure
1. Choose “PowerManager” from the Adjustment menu, and press
.
2. Choose “EcoView Index” from “PowerManager”, and press
.
The “EcoView Index” appears.
Note
• Power reduction: the backlight’s reduction of power consumption as a result of the adjusted brightness value.
CO
2
reduction: converted from the “Power reduction” value, this is an estimate of the quantity of CO
2
emissions reduced
when using the monitor for 1 hour.
*
The numeric value is a result of a calculation based on a default setting (0.000555 t -CO2/kWh) determined by a Japanese
ministerial ordinance (2006, Ministry of Economy, Trade and Industry, Ministry of Environment, civil code article 3) and
may differ depending on country and year.
5-4. Setting DisplayPort Power Save
This function allows you to change the power setting of the DisplayPort of the monitor.
Attention
• For the “On” setting, the position of the window may be changed when the signal is switched. In such a case, turn the setting
to “Off”.
Procedure
1. Press
to turn off the monitor.
2. Holding
down, press for at least two seconds to turn on the monitor.
The “Optional Settings” menu appears.
3. Choose “DP Power Save” from “Optional Settings”, and press .
4. Select “On” or “Off” with
or , and press .
5. Select “Finish” with
or .
6. Press
.
To Next Page
Loading...
Need help?
General