eka MILLENNIAL MKF 2011 TS - Possible Alarms

36
4 Troubleshooting
Type of fault
Cause of the fault
Corrective action
Control panel totally off
(the oven does not work)
Non conforming connection to the
power mains
Check connection to the mains
Mains voltage not present
Restore power supply voltage
Electronic board protection fuse
(with microprocessor) blown
Contact a skilled technician
Cooking cycle activated:
the oven does not work
Door open or ajar
Close the door properly
Magnetic sensor damaged
Contact a skilled technician
Steam cycle activated:
there is no steam
production in the cooking
chamber
Non conforming water mains
connection
Check connection to the water
mains
Closed stopcock
Check the cock
Obstructed water inlet filter
Clean the filter
Damaged water inlet solenoid
valve
Contact a skilled technician
Steam generator safety
thermostat activated
Contact a skilled technician
Closed door: steam
escapes through the
gasket
Non conforming gasket assembly
Check gasket assembly
Damaged gasket
Contact a skilled technician
Loosened handle "nose"
Contact a skilled technician
The oven does not cook
evenly
One of the motors is locked or
turns at low speed
Contact a skilled technician
The motors do not reverse
direction
Contact a skilled technician