25
In addition to the possibility of transferring in
the setting and storage mode, a data transfer is
also possible in the test mode with an activated
Bluetooth
TM
module. Following the test, the
Bluetooth
TM
module is turned on while the test
values are displayed (5, 6) in order to enable a
transfer of data, e.g. the last tested values. (The
success of this option depends, however, on the
PC software used for presenting the tested data.)
The procedure for turning off the active
BluetoothTM function is consistent with the
procedure for turning it on as described on
page 24.
Attention: To decrease energy consumption,
the Bluetooth
™
module should not be activated
permanently, but rather only for the purpose of
transferring data. The reach of the Bluetooth
™
connection is no more than 10 metres without
spatial barriers. The functionality of the device
can be inuenced by strong electromagnetic
elds (e.g. in the proximity of radio towers).
5
6
Display during a test with an
active Bluetooth
™
module
Display after a test with an
active Bluetooth
™
module
To Next Page
Loading...