EKOM DK50 2V/50 - Page 51

PRODUCT MAINTENANCE
06/2020 51 NP-DK50 2V 50, 2x2V 110-A-5_06-2020-MD
PROCESS:
Jumper installation (A-B-C-D process)
 Disconnect the product from the mains by pulling the plug out of the socket.
 Remove the cover on the electrical panel (on the compressor).
 The jumper is not in the terminal strip – A.
 Lift up the fuse cover – B.
 Insert the jumper into the terminal strip – C.
 Close the fuse cover – D.
 Reinstall the cover on the electrical panel.
 Connect the device to the electrical mains.
 Activate the compressor by turning on the switch on the pressure switch.
Fig. 19: DK50 2V/50
230 V
B
C
D