en
R
www.elcometer.com5
2 GETTING STARTED
1. Rotate the probe plug to align the pins
2. Screw in the collar - clockwise
Fitting the batteries
Your gauge is supplied with batteries ready to fit. To insert or
replace the batteries:
1. Lift the latch at the back of the gauge and
rotate anticlockwise.
2. Remove the battery compartment cover.
3. Insert 2 batteries (type LR6/AA) taking care to
ensure correct battery polarity.
4. Replace battery compartment cover and rotate
the latch clockwise to close.
The battery condition is indicated by a symbol in the top right of the
display:
• Full symbol (orange) = batteries at full capacity
• Empty symbol (red, flashing) = batteries at lowest sustainable
level
To maximise battery life, ensure that Auto Screen Brightness is
selected, or the screen brightness is low via Menu/Setup/Screen
Settings/Screen Brightness and the Bluetooth (Model T) is
disabled (if you are not using it) via Menu/Bluetooth and uncheck
the Enable Bluetooth radio button.
Connecting the probe (separate gauges only)
+
1
2
+
+
To Next Page
Loading...
Need help?
General
