ELECTRO FREEZE Shake Model CS705
184592
35
12 Routine Maintenance
Electro Freeze recommends the following sched-
ule to help maintain your equipment in like-new
operating condition. Take the time to learn and
perform these routine procedures and receive in
return many years of valuable service from your
freezer. Protect your investment.
DAILY
1. Disassemble, wash, rinse,
sanitize, air dry, reassemble and sanitize
all parts that come into contact with the
mix or product.
CAUTION
To prevent bacteria growth,
remove all O-rings when clean-
ing. Failure to do so could create
a health hazard.
2. Clean and sanitize syrup lines
with sanitizing solution.
3. Clean the cylinder and drain tube
with the appropriate brushes.
3. Upon cleaning, inspect and
lubricate all seals and O-rings as in-
structed that come into contact with mix.
Replace any O-ring that is worn, torn, or
loose-fitting.
4. Wipe all exterior surfaces of the
freezer to remove any splattered mix.
5. Check overrun and temperature
of the product.
WEEKLY
1. Carefully inspect all parts for
wear including, seals, O-rings, mix
transfer tube and blades.
2. Replace as required.
Replace blades if worn 3/16" or
more.
3. Check the beater tangs and
drive shaft for wear.
A worn coupling will have a nonparallel
shape on the drive opening.
4. Check the air filter and clean as
necessary. After cleaning apply spray
adhesive, p/n HC162548.
GOOD SHAFT
TANG
To Next Page
Loading...
