Electro-Voice EVID-S - EVID-S5.2 T Speaker 5 Cabinet 70;100 V

2. Wire the jumper connector in the Euroblock, according to the desired transformer
settings.
3. Plug the Euroblock connector into the input panel.
4. Attach the flush input cover (A).
A
EVID-S5.2T speaker 5” cabinet 70/100V
Configuring the transformer settings
To configure the transformer settings, do the following:
1. Select the desired power tap by using the rotary switch on the input panel.
+
A
4.3.2
en 17
Electro-Voice Installation manual 2017.08 | 01 | F.01U.345.360