Programming and Configuration Manual
11
3.2 SHOW INPUTS
Activate the SHOW INPUTS menu.
The display will now show input functions that can be detected:
• SERVICE BUTTON
• SERVICE 2 INPUT
• O.H. INLET AIR
• O.H. OUTLET AIR
• DOOR CLOSED
• VACUUM
• O.H. DRUM MOTOR
• O.H. FAN MOTOR
• INLET AIR TEMP.
• OUTLET AIR TEMP.
• RMC
• DRUM MOTOR (used on machines with MCU)
• MOTOR
• GAS ERROR (active low)
• LINT DOOR
• CONDENSER TANK
• COIN 1
• COIN 2
• COIN 1 EXTERN
• COIN 1 IPS
• PRICE REDUCTION
• START/STOP
• FREE START
• PRICE PROG.
• MACHINE STOP
• BLOCK START ACTIVE
• POWER CONTROL
• HP LOW PRESSURE
• HP HIGH PRESSURE
• JUMPER 1
• JUMPER 2
• JUMPER 3
• INTERNAL FILTER
• INTERLOCK AND BUTTON (submenu interlock and button 1–10)
Activated or inactivated function is indicated by:
■ (or values) = Active
□ = Inactive
X = Not available on the machine
Z = The machine is prepared for the function on an extra I/O board but not activated
3.3 MCU
This setting is only used on machines with MCU.
Shows the MCU status.
To Next Page